Posted by Wardner on September 07, 2011 at 14:34:30 from (209.86.226.40):
I just received my PS plug for the PS valve. It was not packaged in an IH wrapping.
I can take measurements with my digital vernier calipers and post them here or I can have a machine shop make a bunch of the plugs. I can stop by the machine shop tomorrow and get a quote. Let me know what you want to do.
Not sure if D Slater's pipe plug will work but then he has a much better understanding of the system than I do. The largest diameter of the plug slip fits into the third bore of a non PS service valve. It appears to float like a shuttle valve shuttle. Not sure if the third hole in a PS valve has a counterbore to lock it in place.
The seller I purchased the plug from may already be reproducing them. If so, I would imagine he has another already listed. I haven't seen it though. You could email him through eBay.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.