Simply put, the first moldboard and share should cut its full width. Share just inside the vertical wall of the furrow. The second and third will take care of themselves. THe plow should be level in the ground with all shares cutting the same depth. The tractor right wheel should be nice and tidy in the furrow such that its sidewall is rubbing gently against the vertical edge. THe front wheel should be adjusted so that it stays in that location while it is also gently rubbing the vertical wall. Hitching so the tractor is pulling from its center is good, but 1 or two inches won't matter much. The land tire should be adjusted the same amount out on the axle as the furrow tire so the tractor pulls evenly. That is the best I have. I plowed with H and M for several years successfully. One last point. The people at the plow day will share and help. Do not expect this information to make you able to argue with anybody. Setting up a plow to be efficient and turn over sod so it covers is an art, not a science. Listen closely to those with M tractors pulling similar plows!! As a plow's landslides and moldboards wear, the little adjustments to tweak it perfect will happen. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
