Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: hot IH H


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by john d on August 16, 2000 at 18:03:03 from (206.141.74.34):

In Reply to: hot IH H posted by Bill Geer on August 16, 2000 at 15:25:51:

Okay....overheats to the point of boiling over and losing fluid? Or just to the point of putting the temp gauge in the HOT area? If it's losing fluid and the temp gauge isn't nearly pegged to the right, it may be time to replace the pressure cap on the radiator. DON'T remove it when the tractor is hot!!

If the cap is okay, the next thing to check is to see if the fan belt is tight! If that belt can slip on the pulleys, the fan will not run at full speed, and this can cause the tractor to overheat. The belt is tightened by moving the adjustable pulley on the waterpump shaft. It's quite likely that it hasn't been moved in a while, so DON'T get in a hurry, or you'll be out some time and several $$. There is a setscrew on the hub and it has a locknut on it. Lots of penetrating oil, patience, and your favorite swear words will loosen it eventually. Rock the hub back and forth on the threads to get it broken loose, tighten it, and re-install the setscrew into the notch on the assembly.

If the belt is tight, and you haven't checked to see if the water is flowing in the radiator, LET THE TRACTOR COOL OFF, then remove the radiator cap, and start the tractor. Let it run a while to warm it up and see if the water is flowing in the top of the radiator. You can hasten this process either by putting it under load, or removing the grill assembly and covering the front of the radiator with some newspaper to stop the air flow. Once the tractor is getting very warm (but not overheating) you should be able to see water moving in the radiator. No movement is a clue to get the thermostat replaced.

While the grill is off, (and the tractor is not running) take your garden hose and wash all the accumulated dirt out of the radiator fins. Wash it first from the back side, forcing the dirt forward. Don't be surprised if the lower third of the radiator fins are clogged.

If you get this far and you still have a tractor that overheats, you may need to have the radiator cleaned out. They are not fun to remove; patience and the rest of your vocabulary will get you through this.

Beyond all that, it's possible the ignition timing could be off and be a contributing factor, but that's not usually an item to bet on.

Good luck, and post back with more questions or info if you need help. This board usually has someone who's already been through whatever you're into!



Follow Ups:




Post A Followup

:
:

: Re: Re: hot IH H

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle? ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy