Posted by David Lampman on August 23, 2011 at 18:45:46 from (69.54.29.239):
Hi Guys, I've finished my block change/rebuild on my Super A. It's running great with no leaks, inside or out!! But during the build I ran into a snag that I thought you guys could help me clear up. When I went to install the sleeves that I took out of the original block into the new block, they were too small. So I had to use and reinstall the sleeves that were in the new block. The original block has the serial# 251069R1 (1948). The new block has the serial# 354898R1 (1954). When I was looking through the parts listing on this site I saw that there are serial number groups. Group 255418-310299 seems to be the most prevalent in the parts listing. As you can see, nether the old block or the replacement block fall into this serial# group. So how many different sleeve sizes and sleeve seal sizes are there? Is it one for pre 255418, one for 255418-310299 and one for above 310299? And what about the width of the sleeve seal groove? I bought new sleeve seals here on this site (they only offer one size sleeve seal)and they turned out to be O-rings that were WAY to narrow and I don't think they went deep enough into the groove either. I'm really confused about this one. I was able to solve my sleeve seal dilemma but that's a story for another post. What do you think? Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
