Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: f-12 It's all done now she won't start


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by F14 on August 16, 2000 at 03:56:18 from (216.252.28.87):

In Reply to: f-12 It's all done now she won't start posted by Carl Holloway on August 15, 2000 at 18:43:49:

If it smells flooded, you'll never in this lifetime crank it hard enough to get it dried out and running.

Check your float setting, and don't over-choke it.

If your fuel pump is questionable, set up a temporary gravity feed using a lawn mower tank to feed the carb.

Check to see that you're getting a good hot spark at the plug. I've been known to heat the plugs up with a propane torch to dry them out and clean them up. It helps.

Double check to make sure you have the valve lash set right. If one or more valves aren't closing all the way, you get little or no compression, and it won't start.

Once I got my carb tweaked right, the mag timing spot on and the plugs cleaned, mine will usually start in one or two cranks. [Unless someone I'm trying to impress is watching ":^( ] I use the following procedure:

1. Fuel on
2. Trans in neutral
3. Mag advance to just over half-way
4. Crack the throttle just enough to put a little tension on the spring.
5. No choke unless it's quite cold, say 40 degrees or less.
6. Crank slowly until it comes up on compression, just before the impulse clicks. You may go past a couple of times until you get a feeling for where this point is.
7. Pull up sharply.
8. Repeat 6 and 7 until it starts.

If, after a couple of good pulls, it doesn't at least fire, try ONE PULL with the choke on. It's easy to flood, and when you do, you might just as well go have a cup of coffee until it evaporates.

Hope this helps. Let us know how you make out.


Follow Ups:




Post A Followup

:
:

: Re: Re: f-12 It's all done now she won't start

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy