It really all depends on who is doing it,but believe me,you CAN tear the crap out of the sheet metal with sand(as well as other media.)It is not just the abrasion of the sand,it has alot to do with the heat generated on the steel.ALSO,alot to do with the CFM of the air supply of the compressor and size of the equipment.My family did it for several years.You ought to see the king of damage you can do with a 675 CFM compressor and a 2" feedline with a 5/8"or a 3/4" nozzle !!!! I have sent out sheet metal that looks in good condition when it comes back,but after you start body working the metal,you can REALLY see and feel the "wave" in the surface that was left behind by a "harsh" sandblast job.I am not saying sand cannot be used,but the safer medias made for body panel cleaning are MORE fool proof.LESS likely to tear up anything under all kinds of different air pressures,CFM,distance from panels.It really is mostly to do with the person doing it,and on RARE parts being blasted,it AINT worth taking a chance on !!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.