Posted by Farmallb on August 02, 2011 at 14:48:11 from (67.142.178.22):
In Reply to: F20 help please posted by elroysdad on August 02, 2011 at 05:50:11:
As was said. Get another tractor with a belt pulley. put a hammermill belt on the 2 and start it up, WITH THE GAS OFF. When its just setting there humming, open up the gas. When it starts popping and back fireing, cut the gas back 1/2 ONLY. Make sure there is STILL a bit of gas going in it. It should still be popping ect. Now, if you KNOW that your wires are correct, And you might tell us how you have them in the mag, from the Fan back to the gas tank. Anyway, then just start walking them round the mag. If the mag is set right, Youll hit it soon enough and it will run like a chanmp. BUT IF, you go all the way around it, and it hasnt started yet, Take the mag to a mag shop and have them look at it. My Boys got a WD AC I bought him. It ran when I bought it, But, the coil was gone in it and somebody had put an external coil on it, It sat here now round 2 yrs and wont start. I bought a new coil, and we worked and worked. Nothing but what your hearing, I took it to a reputable mag man, and he took it apart and found that it was 2@ out of kilter. Were going to start it in 2 weeks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.