Posted by rustred on August 02, 2011 at 08:32:30 from (74.200.18.156):
In Reply to: Re: F20 help please posted by elroysdad on August 02, 2011 at 07:27:47:
i believe your correct on the gears. carb setting to start with, main jet 2 1/2 turns out. idle mixture 1 1/2 turn out. this screw is out for lean and in for rich. have mag bolted to base. get #1 on compression. line up timing mark to TDC. raise breaker housing to retard spark and remove it.lift timing hook to make impuse coupling in operatable.remove dist cap.rotate mag by coupling clockwise as from coupling end. rotate till the brush is coming into alignment with cap terminal #1.just as pionts are opening you are now in time. you can put a piece of paper between points to feel when they open. just as paper pulls out you are timed. without moving a thing put the 2 bolts in the coupling where they line up directly across from each other. replace cap and cover. to check yourself crank engine over on #1 compression and check points , just as they are opening the timing marks should be in line. release timing hook and start tractor. as for compression i would say 80-90 psi.it will run good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.