Posted by pete 23 on July 27, 2011 at 18:36:47 from (74.32.234.149):
In Reply to: Hytran posted by CNKS on July 27, 2011 at 14:56:35:
Hy tran is a multi weight oil, always has been. There were two different weights available , however, I never saw any dealer carry the lighter weight and we did not at the dealership I worked for 40 years. The normal one we carried was about like a 10W-30 oil according to the Viscosity oil company that blended the oil. I don't know of any heavier weight hyd trans oil but there could be some. As far as the clutch, yes, they can be tough to get a quick release with that TA planet so easy to keep right on turning and also the pto shaft running inside of the transmission tends to carry the motion. One thing I have done a lot on tractors using the four pad disc with seperate fins, not one solid circle, is to bend the pads just a trifle so they spring away from the flywheel upon clutch release. Only takes about .030 at the tip of each pad. I also adjust a lot of clutch fingers from underneath to get them all very close to the same. It is amazing how you can adjust a pressure plate on the clutch adjusting stand and then bolt it down to flywheel and get different readings. Even a pilot bearing that is stiff can give you problems as well as you are aware I am sure the splines and proper lube on them. No two clutchs ever work exactly the same on same model tractor new or repaired. Most are close of course but never exactly alike.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
