Posted by 36F30 on July 18, 2011 at 19:15:36 from (71.214.211.46):
In Reply to: farmall F20 posted by blayne on July 18, 2011 at 18:02:03:
The F series originality guide is packed full of good info.
The bolts have a pattern to hex and squares but it is NOT absolute. Generally speaking Square headed bolts go through parts and have nuts on them, Hex headed bolts go into blind holes. On a 36 most of the hex bolts have dots on the heads.
Originally the radiator was unpainted brass, I mist mine with black for looks but don't put it on too thick or it affects cooling. A bag was put over the mag and the oil gage and sediment bowl glass were masked off and then the entire tractor, manifold and all was painted grey except for the draw bar and wheels which were red.
I paint manifolds and exhaust with high temp black paint. And mask off all the brass fittings and leave them bare
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.