Posted by Rick Remmert on July 17, 2011 at 19:57:47 from (68.103.15.145):
I am finally going back together with the saved from the scrap pile mower. The guys on the implement page have been a big help so far. We have still not figured out what model it is for sure. I got the owners and parts manual for a 2C-F24 and 34-F24 after sending back the ones for the C-24. These are all very close to what I have and many of the parts are similar, but still not 100% matching. The high speed wheel on mine is offset to the side of the pitman wheel. On the others, it is one above the other. My high speed shaft mount has plates on the front and back. The other ones have them on the side. I also do not have the right side rear axle mounting system that fits on the clamp. I do have a bracket that adjusts the up and down for the sickle bar, but I can not figure out how it mounts to the tractor. It is shown in one of the pictures laying on the hydraulic cylinder. I hope the paint police have retired for the night. Painting the whole thing will happen this winter when I have more time. Anything that had to come apart to be rebuilt got sandblasted and painted with what paint I had. I am suppose to be helping mow 190 acres of Boy Scout camp grounds but with no rain and 100 deg. temps I brought myself some time. I just thru the whole tractor picture in because someone always wants to see the tractor on this page. I figure someone on this page has to have one of these mowers mounted on a "C".
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
