Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 706 Trans Inspection Plate?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SDman on August 11, 2000 at 10:56:26 from (208.248.137.139):
In Reply to: Re: Re: 706 Trans Inspection Plate? posted by Red Rookie on August 10, 2000 at 11:20:26:
Red Rookie, I'm sorry but I don't follow where you are describing. On the engine side, behind the flywheel, will be a retainer that the rear main fits in(its tough to see as the flywheel pretty much covers it up). On the trans. side, behind the throwout bearing assembly, will be a 4-6" circular cover that covers the PTO gear; around that will be a 10-12" circular cover that covers the front part of the TA, if equipped, or the countershaft drive gear if there is no TA. There are no gaskets here, just O-rings & lip seals. Also, there is a smaller 4-bolt round cover at the bottom of the trans. housing that covers the transmission countershaft. It is also an O-ring. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|