Posted by MT in Walford on July 16, 2011 at 17:04:40 from (67.55.154.239):
Church to Church tractor ride will be Saturday, August 6, 2011. Get registered today! We will start Saturday morning Aug 6, 2011 at Clover Ridge United Methodist Church in Walford, Iowa. We will have breakfast together at 7:00 am. (If you register your tractor you will get breakfast and lunch included in your registration for the driver) At about 7:30 am we will have a drivers meeting. We expect to leave Walford at 7:45 am or so. We will be traveling down through Swisher Iowa and North Liberty Iowa to have noon lunch at the Oxford Hay Expo, near Oxford, Iowa. The Oxford UM Church ladies will be serving a meal there. We will spend some time after lunch enjoying the Oxford Hay Expo and then for back to Walford in the later afternoon. If you choose to leave your tractor at Oxford Hay Expo on Sat night we will have a shuttle to get you back (later afternoon) to the Walford church to get your truck/trailer. The registration fee is $40 dollars. You need to send the signed registration fee and signed safety pledge along with your check made out to Clover Ridge UMC, to this address: Clover Ridge UMC, P.O. Box 87, Walford, Iowa 52351. We do require these things: A rear view mirror on your tractor, a Safety slow sign on the back of your tractor, driver must have valid drivers license, you carry liability insurance, buddy's in a buddy seat are allowed, no passing. We hope you will come and we hope to make this an annual tractor ride. email me at miket@southslope.net and I will email you the registration form and the safety pledge form. Thanks Pastor Mike Townsley
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
