Farmall & IHC Tractors Discussion Board |
Re: 606 Interchange
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kev in iowa on August 10, 2000 at 19:11:27 from (207.177.4.168):
In Reply to: 606 Interchange posted by Jack on August 10, 2000 at 15:57:51:
It is supposed to have a C-221, as did the 460, the other motors of that series will bolt up but they all have more stroke, hence more torque, the clutch won't last. 560s have a bigger clutch, if you saw a 460 and a 560 side by side you would see that the side frame curves in to match the smaller clutch houseing, can't even install a 560 clutch on a 460, bummer. All this is assuming you would use it for farming, if tractor pulling, heavy pto work or other nonstandard activites, maybe. A 606 is very rare in my area, why not hot rod a 560? Very common, and there are guys out there that know how to do it. My two cents. kev
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|