Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: New replacement rims for a Farmall C?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Larry Ks on August 08, 2000 at 07:06:32 from (209.242.110.122):
In Reply to: Re: Re: Re: Re: Re: New replacement rims for a Farmall C? posted by The Red on August 07, 2000 at 11:21:37:
Skeeter....the C rims are mounted with 6 or 8 bots and nuts. The original rims have mounts that are riveted to the rim, and then they are bolted onto the hubs. I wouldn't be afraid of the blank rims. I'd bet that if you're really wanting to be "original" that you could drill the rivets out of your old rims and then redrill the new and rivet them back in, or if you don't really care, you could simply weld them in place. One more suggestion.....I have a C that the calcium had fouled up....I had another old rim...I cut out a replacement piece and welded in my rim, ground smooth and you'd never notice it now....If bought one new rim, you'd probably have more than enough to do both rims....just a thought. If you choose this route, you'll have to drill a new hole for your valve stem...I did mine a few years ago, and has worked fine every since. I know I'm going on and on, but was just sitting here thinking...You could take your old rims off, drill the rivets out, rebolt the mounts to the hubs, and then set the new rims in place (using some kind of spacers to make sure every part is even), tack weld, unbolt, and rivet, grind off the tack welds, and you'd have perfect new rims. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|