I'm going to key in on your statement "it often starts runing very rough" and maybe take a different slant on your problem. Does your engine really run rough or is it simply surging? If it is rough, you need to make sure the fuel and ignition systems are in order before you get into the governor. Maybe you need a tune-up. If the ignition is in shape and the caruretor is delivering enough fuel, the next thing to check is the linkage between the governor and the carb.
With the engine off, unpin the forward end of the rod that connects the governor arm to the carburetor. Push the control lever forward. Pull the (now disconnected) rod back so the carb is wide open. The pin in the linkage should be able to slide back in without moving the other parts. If it doesn't, turn the yoke on the front end of the rod to the longest adjustment that will let the pin slide in. Make sure that link moves freely with no binding.
Only AFTER doing all this, remove, clean and adjust the bumper spring as already mentioned.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
