Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo Sorry! Our Phone System is Down. Please use our Contact Us Form.

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Re: Re: Cleaning a Gas Tank


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Don(PA) on August 03, 2000 at 18:24:24 from (205.188.199.204):

In Reply to: Re: Re: Cleaning a Gas Tank posted by Brian Schmidt on August 02, 2000 at 19:41:43:

I just finished cleaning a tank off a 44 M -- it was nasty rusty inside! I had tried course sand and agitating it on a chain rig in the shed, but it was so bad that I got out only the loose stuff - a couple of cups! I then followed Spencer Yost's suggestion of using roofing nails (it sounded strange, but it was effective!). Just dump a bunch (I probably had 5 pounds in that big tank) in and agitate the heck out of it. Since the gas cap was already pretty beat up, I wnet ahead and used it to seal the opening - don't want nails all over the farm! A pipe plug closed off the outlet where the strainer was removed.

The agitation was the problem, as hand shaking while suspended just wasn't sufficient. My Dad made a little rig for the side of another M wheel, and everybody took turns driving it around. CAUTION - THAT TANK STICKS OUT AND IF YOU ARE NOT CAREFUL, SOMEONE CAN GET REALLY HURT -- USE YOUR WIDE OPEN SPACES!!! Also be sure it is tied and bolted down TIGHT or it will wiggle around and fall off - damaging something! GO SLOW!

Did that a few times with water, draining and hosing it out with clean water, then using Naval Jelly (phosphoric acid) and water. Keep agitating and when the water gets really rusty looking, drain and flush out. Took me all day! I pulled the nails out with a magnet on a handle -- worked really well. If you keep rotating the tank, they will all come out - just be sure to twist the tank so that the nails can slide down the top of the tank (the baffle is very close to the bottom, but not the top).

But when it was finally done, the inside looked clean for the first time in 8 years! Dry it REALLY well immediately, though, or the water will rust the inside -- then let it sit in the sun open for several hours or days...

Then apply your Kreem or whatever sealer. As bad as the rust was, it did not leak through!

Good luck, and hope however you clean it works out for you. Don(PA)


Follow Ups:




Post A Followup

:
:

: Re: Re: Re: Re: Cleaning a Gas Tank

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity! ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy