Posted by cuttman on June 03, 2011 at 06:31:10 from (184.1.107.185):
I have a farmall b and trying to finish converting to 12v that someone else started. I have a 10SI (3 wire)alternator. the wire from the batt. Terminal on it runs to a ammeter then it comes off the ammeter to the starter switch (10 guage wire) located on the starter itself, then I have a wire (2 guage i beleive) going from their to the positive battery terminal. Now I also have a 12 guage wire with a diode going from ammeter back to alternator on the #2 terminal to excite it. My problem is I charge the battery and the next day it is dead. I haven't used it in the field yet, still trying to figure this problem out, battery is only year old and holds charge when off the tractor and alternator tested good from autoparts store. Please all comments welcome, this is getting frustrating. I used bobs farmall m wiring diagram, still no luck. Sorry for the long post.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.