Posted by equeen on June 02, 2011 at 11:59:15 from (209.102.248.55):
Loads of thanks to all who helped me work thru the timing issue with my Cub - apparently firing on the exhaust stroke.
I went thru all the steps again this morning including "thumbing for pressure" on cylinder 1. Then carefully bumping the engine with the hand crank to get it TDC. When I then looked at the rotor, I knew it was 180 degrees off. So, I corrected that.
Then picked up my new manifold and installed it.
Then poured gas into all 4 plug holes, installed plugs, then pulled the starter rod.
That baby fired up ran for 10-20 seconds and sounded BEAUTIFUL!!
Time and again you folks told me what to do and it seems that I never got things quite right until this AM. Thanks VERY much to each of you who assisted - and for your patience.
After I receive the carb, rebuilt, I'll gas her up, check essentials then, hopefully, go for a slow and short ride. Will post a before and after photo when all is well and ready.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.