Farmall & IHC Tractors Discussion Board |
Re: torque specifications
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Phil Auten (TX) on August 03, 2000 at 04:12:11 from (206.175.72.226):
In Reply to: torque specifications posted by STEVE KRUK on August 01, 2000 at 19:28:35:
Steve, Check out the site linked below. Go to Torque Specs in the Research section. It has everything except the torque sequence. I just start with the bolts in the center of the head and work outward in a spiral pattern. Torque to about 2 thirds of final value, then add half the difference and torque to that and then on the third pass torque to full value. Example: if the final value is 60 ft/lbs torque to 40 ft/lbs, then go around again torqueing to 50 ft/lbs, then make a third pass going to 60 ft/lbs. Retorque after running up to full temp and cooling down and retorque again after running for a few hours. If any fasteners don't hold torque, replace them. Good luck, Phil
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|