Posted by Janicholson on May 26, 2011 at 14:05:47 from (67.72.98.45):
In Reply to: farmall M voltage reg posted by Finnbair2020 on May 26, 2011 at 13:53:35:
The contacts you are touching are the cutout relay set in the VR. If the generator is a three brush style, move the third brush all the way as close as possible to the fixed brush on that side. This will boost charge to get the relay to latch. If it is not a 3 brush, try this. With the tractor at 3/4 throttle, and all wires connected, ground the F terminal on the generator with a jumper. If it now latches, the VR voltage relay might have dirty contacts. The VR will not act correctly if the cover is off because it has an effect on the magnetism in the unit. Be sure to check operation only with the cover on. If it still will not latch, and the generator puts out well when working I would reduce the spring pressure on the contacts you are pushing on. (this is not easy, it is touchy, and is responsible for opening those very contacts when the engine is idling, or stopped. Be sure the contacts open when the tractor is shut off or it will smoke the generator, and discharge the battery. Adjust just tiny increments. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
