The cap or cup over end of valve is pushed down with the decompression mechanism and is under neath the rocker arm shaft. If you wanted to take the cup off you would have to remove whole rocker arm assembly. They are a regular shaped valve but very small, and open into the spark plug, gasoline side combustion chamber therefore lowering the compression ratio for starting on gas. Usually you can get them to move down a little but getting them to move back up is a little harder. You might be lucky and be able to do so from spark plug hole but those two center ones are really hard to get at. May have to take manifold off. They have to move totally free and also not leak when seated. They are very prone to warping when not cooled on their seats. That is why I suggest checking by cranking with spark plugs removed with lever in diesel position as first of all if stuck open you will have total compression leaking out through the plug hole and if they are closed but leaking you will have some leaking. A slight leak can be tollerated .There are other ways to also check them but this is simplest.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.