Posted by caseman-d on April 22, 2011 at 16:37:15 from (67.142.174.23):
Working on a farmall 400 engine. Started out it had a knock and found piston ring broke and some how got hast the wrist pin and gouged the sleeve. I replaced the piston, sleeve and rings. When I honed out the other sleeves I found number 3 looked like it had a crack in it. I pulled the sleeve and found what looked like a crack in the block. Picture one kinda shows it.
I attempted to trying some loctite lose fit sealant. In this fruitless attempt I cracked the sleeve installing it and pulled the sleeve pack out, hone the cylinder wall and found which looked like a bigger crack else where to the right of original crack.
After looking at the pictures myself I am beginning to wonder if the crack maybe some of the loctite not completely honed off. Since this is a dry sleeve application do you think a new sleeve would solve my problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.