Posted by Seth Boyer on April 21, 2011 at 19:45:09 from (75.120.184.218):
In Reply to: mw clutch posted by old mack on April 21, 2011 at 12:59:24:
Quoting Removed, click Modern View to see
John when I was rebuilding my M&W clutch on my H I ended up destroying most of the fiber discs. When you get everything off down to the discs you should be able to tell how the outer circumference of the fiber discs and the inner part of the drum are splined. In my experiance there was enough corrosion built up that it did not allow the fiber discs to just pull out easily. Maybe with enough patience you can use a file...wire brush...ect... to clean it out and this would allow you to pull them out. Then of course between each fiber disc will be a metal plate that will have splines on the inner shaft. Good luck.
I know where you can get parts if you need them. Let us know what you run into.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.