Farmall & IHC Tractors Discussion Board |
Re: Super A Tune-Up
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by p on July 28, 2000 at 16:06:21 from (12.33.190.5):
In Reply to: Super A Tune-Up posted by Stan on July 28, 2000 at 15:53:16:
The rotor will move a bit but there should be spring tension on it. This is the advance spring for the timing at high idle. To set the points, turn the motor over until the points are at the point that they are the most open. Then adjust the opening(gap) to the specification, I believe it is .020, but check your manual. The Red has suggested setting it at .017 if there is alot of slop in the shaft, I have never done this but it makes sense. Your timing should then be the same as it was before the tuning but it might not hurt to check it. Too advanced and it could be detrimental to the motor and too retarded and power would be adversely affected. Adjust the timing according to the manual. IF you have no manual post back and we will help. Please then post whether it is a distributor or magneto.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|