Posted by Tom Fleming on April 20, 2011 at 03:19:26 from (67.20.243.240):
In Reply to: Red Tractors posted by southdakota farmall3 on April 19, 2011 at 18:54:10:
Lots of Cub parts out there. The only thing to consider on a Cub, is that it is NOT a sleeved engine. If the cylinders are fairly worn, you will have to send the block out to be bored and honed to the next correct oversize that pistons and rings are available for. There is a practical limit as to how much overbore you can go.
Other than that, they are a fun little tractor that have more uses that you would think. I don't think that a better snow plowing machine exists. small, manuverable, and surprising push power with weight and chains. If you put domes pistons in it, you can squeeze a bit more HP out of it. It is 9 HP at the belt and 8 at the drawbar.
Been using one for a 1+acre garden for years. Plows, disks, hills potatoes, cultivates, plants corn, etc.
I like all sizes of tractors, but the Cub is great for smaller jobs and general around the house/farm chores.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.