Posted by El Toro on April 13, 2011 at 11:47:52 from (108.3.156.106):
In Reply to: Re: Ignition switch posted by Albo5000 on April 13, 2011 at 06:28:01:
You should see if you have battery voltage at your coil with the points open and the ignition switch pulled use a volt meter or test lite. The starter is a separate circuit as it just cranks the engine. You should be able to hand crank that engine and start it when the ignition switch is pulled. Make sure the tranny is out of gear before doing this. If there's no voltage at the coil you need to check for voltage back at the switch. There should be voltage there when pulled on the terminal that feeds your coil voltage. If there's no voltage there check the feed terminal on your switch for voltage as there should be voltage there all the time unless you have a broken wire. Hal
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.