Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  

Re: HELP = Strong Gasoline Smell on Oil Dipstick ??????


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by horsepoor on April 13, 2011 at 05:38:37 from (208.124.126.217):

In Reply to: HELP = Strong Gasoline Smell on Oil Dipstick ?????? posted by DRL on April 02, 2011 at 20:23:23:


sflem849 said: (quoted from post at 13:47:57 04/04/11)
mkirsch said: (quoted from post at 05:44:33 04/04/11)
sflem849 said: (quoted from post at 05:30:44 04/03/11) The float sticking will cause it to fill the crankcase with gas. It is always a good idea to turn the gas off when you let your tractor sit.


It is practically impossible for the crankcase to fill with gas from a stuck float.

First off, the carb is an UPDRAFT. It is positioned BELOW the intake manifold.

The carburetor and the manifold would have to completely fill with gasoline before any started running into the cylinder. If that were the case, it would be so flooded that it would never start. It would hydrolock on the first crank over.

Second off, there is a drain on the carburetor that lets the gas run on the ground if the carburetor floods. That would have to be plugged before the gas would start filling the manifold.

Third off, the air intake isn't always a perfect seal. Gas would run out around the hoses even if the carburetor drain is plugged.


But it could happen...I agree though. As I got to thinking, it probably wouldn't happen. Your tank would have to be plumb full and a bunch of other stuff. I was pulling off prior experiece with small engines. There it is a lot easier to have happen.


Farmall Cub fuel capacity = 7.5 gallons

1 gallon of gasoline weighs 6.073 lbs

45.5 lbs of liquid weight ABOVE the carburetor, yeah it won't push thru a stuck float and 60 year old rings. Look at what he is saying the problems are.

1.) "Tractor spins longer than normal before it fires. " I would thing the plugs are wet.

2.) "Once it fires like it wants to run, it takes a little bit of choke to get it going from initial fire." Choke helps weak sparkies, that might be trying to burn off gas.

3.)"After the tractor sits and runs for approximately 2 minutes (without choke) at half throttle, it suddenly wants to die. If you play with it, the choke, the engine will stay running." Might be due to a stronger spark since you're burning excess gas.

I would look at the carburetor, and rebuild it. Completly clean all the passages. If it is a stuck float, that would explain alot of this. 45 lbs of downpressure would push UP thru the manifold. GRAVITY WORKS!

-Horsepoor

This post was edited by horsepoor at 06:04:33 04/13/11.



Replies:




Add a Reply

:
:
: :

:

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


 
Advanced Posting Tools
  Upload Photo  Select Gallery Photo  Attach Serial # List 
Return to Post 

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy