I have not looked, but if they are like other Farmall seals, they drive in from the outside and you dare not drive them on in to remove them (I am talking from experience). I have removed seals successfully by using a couple of self taping screws. Tap the screws into opposite sides of the flat part of the seals metal ring. If the seal is stuck you may have to drive it in just enough to break it loose. Using the screws a big screw driver or flat pry bar often is all that is needed to pry them out. Understand that you destroy the old seal when you use the self taping screws so you have to stick with it once you start. If the screws strip out just move them over and pry again. In a pinch you can simply enlarge the holes and use a pointed pry bar (ice pick type) to pry the seal out. Do not leave any metal filings behind before installing your new seal. Be sure the shaft is absolutely smooth where the new seal has to work and do put a little grease on the shaft before you install the new seal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
