Posted by ericlb on March 31, 2011 at 05:44:04 from (75.107.64.56):
i just remounted the 42" mower to my cub, i took it off so i could use the cub to push snow this winter [ have the factory snow/grader blade], how nice, not to have to turn my head around to watch a rear blade!anyway,late last year was the first time the cub ever had a mower on it, and i had some noise from a bearing in the transmission when i installed the belt pulleyand tightened the drive belt for the mower, this year its more noisy, using the old ear and screwdriver trick, it seems to be the bearing between the tranny and differential, [may be wrong] can i split the tractor at the differential and roll or carry the whole rear end assembly to the rear to get at it? or do i have to completly dissassemble the rear end assembly, [ final drives, tubes, ect] also can i split in front of the tranny between the touque tube and tranny, or do i have to split at the bellhousing? i know there is a bearing in the front too, i plan to run this cub hard this summer and im trying to avoid bearing failure during the summer, thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.