Farmall & IHC Tractors Discussion Board |
Re: M hydrolic leak
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on July 24, 2000 at 04:49:46 from (12.75.196.181):
In Reply to: M hydrolic leak posted by bruce on July 23, 2000 at 19:33:52:
Bruce remove the small rear plate between the liftall and the transmission. More than likely the liftall is leaking at the liftall coupler and possibly through the liftall reservoir gasket. If that is the case, you will need a coupler seal and a reservoir gasket. To remove the liftall, drain the oil and remove the filler and outlet pipes and disconnect the activating arm. Turn the dog and female coupler on the liftall vertical. I don't recall if there is a drive shaft between the dog and coupler on the M. The parts book does not show one. Get help to remove the liftall. It weighs a good 100 pounds plus! I have not had an M liftall apart so I will pass the torch at this point.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|