Posted by rustyfarmall on March 17, 2011 at 16:11:12 from (209.152.78.140):
In Reply to: Setting carb on M posted by old on March 17, 2011 at 15:40:22:
Quoting Removed, click Modern View to see
Low speed idle (air) is 1 1/2 turns out. Leave it right there until the engine is fully warmed up. Then, and only then, you MIGHT need to turn that screw in OR out, but 1/2 to 3/4 of a turn in either direction should be sufficient. If it is NOT, it's time to take the carburetor apart again 'cause you missed something.
The high speed idle, or load adjustment screw is set at 3 turns out. Period. Leave it there. Adjustment is required ONLY, and I repeat ONLY, if the engine stumbles under FULL LOAD. Not just at wide open throttle, but at FULL LOAD.
Every M or H that I have ever been around always made full horsepower and performed very well with the load screw set at just 3 turns out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
