Years ago I had one of those one piece adaptors. IMO, iunless you're using it for light duty, mowing, light blade work, or something similiar they are not heavy enough & donot allow very good front to back adjustment of the implement.
I bought a set of the individual prongs that had regular 3 pt sockets. The sockets were mounted higher than the hitch prong & were made so they could be set for CAT I or II. They were made so they would pivot by removing a pin so you could swing them out when backing up to an implement then swing them in over the implements lower link pins. Not the best description, I had pics but can't find them. :~( But they were as close to a 3pt lower link assembly than any other 2-3pt adaptor I have come across and were very strong. I used them on a 806D pulling a #55 mounted chiesel & never had a problem with them. I went as far as putting a CAT II Quick coupler on them.
I sold them back in the mid '70s when I traded off the 806 as all my tractors them had 3pt. About 4-5 yrs ago I bought a fasthitch 756 to use on a sickle bar mower & auger & found a set of adaptors just like I had on the parts phot ad forum here on YTs. Gave $150 IIRC. I traded off the 756 last year for another 806D which was 3pt & sold the adaptors. That's the last set I have seen like them but keep a lookout & you might find a set on here or E-bay. Well worth the money IMO.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
