Posted by Baelee05 on March 15, 2011 at 15:38:16 from (12.192.13.220):
I know there has been a lot of wiring questions lately so I hate to pile on with another but here goes. I posted last winter that I was setting up an M that I got in disrepair on a 12V system. I kind of walked away from it for a couple of months and forgot what was what. It is a 39 M with magneto ignition, a 4 post VR, set up for 12V. The gen shop set the generator and VR for 12V. The following is the way that they told be to wire the tractor. Wire from gen post of VR to ARM post of gen. F post of VR to F post on gen. L post of VR to left post of ammeter. Batt. post of VR also to left post of ammeter. Cable from negative post of battery and wire from right post of ammeter to top post of the starter button. Cable from bottom post of starter button to post of starter. Cable from positive post of battery to tractor frame for a ground. Does this sound right? I looked at Farmall Bob's diagrams and didn't see anything for a magneto ignition with 4 post VR set up on 12V.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.