Thanks, and I should have mentioned it's a mag ignition.
Do you know if any re-wiring will be required going from a cutout to a regulator?
I'm not positive that it actually was a cut-out relay, as it was bigger than any cut-out I have ever saw, but different from any regulator I ever saw.. (not saying I saw a lot of em, but..) I just planned to ask the fella redoing the generator, as he is very knowledgeable.
The best I can describe, it was around 2" square "saddle mount" (typical of the regulators I am familiar with) On one side it had 2 wires, which IIRC hooked each post of the generator to each post on that side of regulator, Opposite side had 1 wire hooked up, and without tracing it, appeared to run back to previously mentioned box.
Sound like it would be wired correctly for a cut-out, or a regulator, or would it be the same either way?
thanks,
Brad
PS.. I may end up going negative ground.. probably be easiest after thinking on it.. I pay attention to hooking up booster cables and chargers.. But sometimes my dad does not..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.