The operating rod is still straight and the lever only has 4 lugs, so indexing should be good. The internal parts look pretty robust and nothing looked bent or too worn. Making a 2" extension seems like a good work around for the short term.
The pump locks in the raise position and lifts like normal. It was getting dark so I just checked it sitting in the shed and didn't run it all the way up. The left cylinder leaks a little and at times squits oil out at full extension.
The previous problem was that when I pushed the rod foward to lower the bucket the rod would bounce back and the and the loader would stop unless I held the rod down. In addition the loader would raise when the rod was on the stop and it did not have much power. I'll give it a little better try out today.
I have an older pump. It has been updated to the 750 psi spec at some point. My parts book only shows the later version. What does the 'hold up ball lift pin' do ? I think I have the earler version of the 'differential check valve lift pin' ( externally, both pins are the same size). What does it do ? The differential check valve, valve ball, and spring (#s 70, 71, 72) are only listed for SN 391364 and up. How did the earlier version work ?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
