Posted by ScottyHOMEy on February 25, 2011 at 21:38:15 from (70.105.230.151):
In Reply to: Re: B Farmall posted by old on February 25, 2011 at 13:09:05:
The A was always offset -- the left final drive mounts up hard to the differentia/tranny with a short shaft transmitting the power between the two. On the right side the shaft was longer and enclosed in a housing. The i8" width of the housing in between is where the seat and platform are. The front would have been a wide-front configuration offset simlarly to the rear.
On the B, the shaft housing on the seat side is 22" in width, so the seat platform is wider to match it. the left side of the rear also has the longer shaft and 22' housing between the diff and the final drive, so that the tranny and driveline are centered between the rears (not offset like the A). The front end of the B was always narrow with either the NFE (two tires) or SFE (single tire).
The only difference between the B and BN is that the shaft housings on the rear are each 18" wide, making the chassis 8" narrower than the B. That 18" measurement is the same as on the right side of the A.
Comparing all three, the distance between the finals (and so the width of the drawbar) is narrowest on the A, 18" wider on the BN and the B another 8' wider than that.
If it has the pan seat on the original type supports, one of the easiest ways to distinguish a B and BN at a glance is how the outboard, right seat support mounts. On a BN, that outer support bolts up to the final drive and shares a few bolts with the fender, just like it does on an A. On a B, that support mounts to a bracket set in the floor pan about 4" inboard of the final drive.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.