Posted by Janicholson on February 25, 2011 at 07:28:05 from (199.17.6.194):
In Reply to: 301 low oil pressure posted by mshultz on February 25, 2011 at 05:57:18:
A plug out of a gallery is a serious possibility. The orthe engine was very different, but many engines do have gallery access plugs in them. These are put in when rifle drilling the oil gallery to clear chips, and other reasons. They are found both internally and externally on the main block (usually cam side). The way that the CNKS (if i recall) found the missing plug was to inject air into a gallery port and listen for the escape of air through a missing plug. The plugs are routinely removed when hot tanking a block to clean the passages. Sometimes the crew leaves them out assuming they will be reinstalled by the assembler. (often) Sometimes they even give the original plugs back in a box!. If the pan is coming off, it will be pretty easy to blow air into the oil pump output hole to see where it is going. Using a mechanics stethescope with the feeler end removed can be very helpful listening to the location of an air leak. I hope this helps, or that it is a pump related issue. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.