The TA is easy to test. With the tractor facing down the road (clear and safe) put it in 5th gear TA back. Wit the throttle open, let out the clutch as though you were almost trying to kill the engine. It should take off forward like a rabbit. When it picks up full speed, shift the lever forward as rapidly as you can (always move this lever as fast as you can every time) the tractor will now be shifting into direst. If you have a nice quick change to direct like an automotive automatic trans shift, it is fine. Throttle down at this point or you will be going 18 to 20 mph. Could be scarry if you are not a tractor driver. If you are not a tractor experienced person have the owner show you this happening on the road while you watch. The PTO should be tested with a pipe wrench on a suitable Pto coupling fitting the shaft.(engine off) Put on the coupling and put a big pipe wrench on it such that it is trying to turn the coupling, make sure the lever is forward and in its catch notch. A 4 foot pipe will help. With solid effort the PTO brake should hold the shaft from turning. Now move the lever to the rear and latch it in the notch. attempt to turn the PTo again with the wrench, pipe, and coupling Clock Wise only this time. IT should now turn the engine and resist slipping. if the tractor is in High gear, it will not turn the engine. If the lever is held in the middle of its travel the PTO should turn easily with little drag. This is about as careful an eaxm as can be given with nothing attached and no thing to bale or mow. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
