You have just been introduced to the number one hydraulic problem on that type of IH tractor. Loss of prime in the MCV pump and not able to pick it up on it's own.
This problem occurs when the O-ring seal between the center section and the rear frame ages and takes a set so that it can no longer form an air tight seal. This seal is located above the normal oil level in the transmission. When the tractor sits without being used air slowly leaks into the suction side of the front hydraulic system. The hydraulic pumps are not very good good pumps for pumping air and when they get worn they are even less effective. You have one more issue that causes the tractor not to move on it's own and that is a worn sprag in the low side of the TA. There are little drag clips on the sprag clutch that are designed to help the clutch engage. These tend to break off with use and without them the clutch will sometimes not engage. When the MCV pump is providing lube oil to the TA the oil provides enough drag that the loss of the clips is not always noticeable.
The correction for the all the problems is to split the tractor and replace the TA and MCV pump. The work-around is to prime the MCV pump and see how everything works.
To prime the pump start the engine and then turn the steering wheel. If that doesn't work, and it usually doesn't, remove the plug on the back side of the MCV assembly that is located below the dump valve spool. It is the only plug there that has a 5/8" head. Start the engine and be ready to shut it off quickly. When it primes it shoots oil back on the rear axle and it sprays all over. If you still can't get it to prime you will need to add a little air pressure to the oil fill hole as you are trying to get it primed.
If after it is primed everything works OK you're good to go. If you find that the tractor loses prime between uses you can add an extra five to seven gallons of transmission oil to keep the oil level above the leaking seal. That will eliminate the loss of prime in the MCV pump.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
