Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Mag Question


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Phil Auten (TX) on July 17, 2000 at 05:18:25 from (206.175.72.226):

In Reply to: Mag Question posted by Brian Schmidt on July 15, 2000 at 20:20:41:

Brian,
It is also possible that the mag has been converted to a distributor ignition. I have one tractor that has been converted and it works, but of course is not original. Either type of ignition will work, the choice is up to you which one you want to keep.
Here's a brief rundown on how both types of ignitions work:
The mag has a spring loaded impulse coupling built in to assist with starting. It's function is to make the spark hotter at cranking speeds and it is no longer employed once the engine is running. It will make an audible click as the engine is rotated by hand. The impulse trips at the exact time needed to cause the magnets in the bottom of the mag to rotate quickly past the small coil of wire that is the primary side of the ignition circuit. The current induced into the primary is then interrupted by the points opening. This causes the magnetic field arount the primary coil to collapse immediately. The collapsing magnetic field induces a current in the secondary winding of the cignition coil which creates the spark voltage for the plug.
The battery ignition works in a similar way, but the points carry current from the battery through the primary side of the ignition coil, building up a magnetic field until the points open, causing the rapid collapse of the magnetic field which induces the spark voltage in the secondary winding of the ignition coil.
The battery ignition is quite a bit simpler which explains the conversion of many mags to battery ignition, or their replacement with a battery ignition distributor.

Hope this is helpful,
Phil


Follow Ups:




Post A Followup

:
:

: Re: Re: Mag Question

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy