Posted by CNKS on February 18, 2011 at 18:48:18 from (216.144.104.128):
I ran the tractor about 2 hours after it finally started. I do not have a good way to break in this engine. I have a Woods belly mower but I have not overhauled it and painted it yet and there is nothing to mow anyway. No other implements and Western Kansas is flat, no hills. I installed a temperature gauge by sawing of the top of the taller outlet from a C123. Gauge is mounted off a bolt on the governor, can be seen from the seat, unlike the gauges on the distillate engines which run off the cold side of the radiator. When running I block the air to the radiator until the needle is nearly in the red, then let it cool some with the engine still running if it is still moving up, then repeat. Machinest, who rebuilts car engines says to get it hot, so I did. There is absolutely no smoke from the exhaust or breather, not on starting, or accelerating or idle. So I hope it is working. All bearings in the transmission and final drives were replaced, along with the reverse idler gear which had a chipped tooth. The transmission is now quiet. One reason I replaced the bearings was to see if what I have read on this forum for the last 10 years or so, is that these transmissons are noisy from the factory. Nope, just normal wear. Gene Bender's experience says the front bearing causes the most noise. Could be, but I wanted to be sure. Main problem now is the clutch. I did not replace it, but It appeared ok, clutch pads had a lot left, plate needed a little sanding. I did replace the release bearing. Clutch is very noisy when engaging. It is the release bearing and the fingers. Probably going to have to split it and replace the clutch. With the old release bearing there was no noise. Going to look at it some more. I don't think I can adjust anything without splitting it. It gets a new clutch if I do. I have asked questions about various things for the last 16 months, I greatly appreciate everyones help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.