Posted by Owen Aaland on February 17, 2011 at 08:01:58 from (63.167.132.13):
In Reply to: Remove front hyd pump posted by Larry B 1486 on February 17, 2011 at 04:48:43:
The pump is not being primed. That accounts for the lack of hydraulic pressure in the control circuits. The cause is going to be a leak at the seal between the rear frame and center section. A weak pump can make this problem more noticeable. The extra five to seven gallons of oil insures that this seal remains below the oil level so air does not enter the system causing the pump to lose prime.
The fact that you were having problems with the steering is cause for alarm. Not just for problems with the steering but it can also indicate the range transmission and differential are not getting proper lubrication.
The MCV pump provides 9 GPM flow to the MCV where a priority 3 GPM is sent to the steering and then to the brakes, seat and diff lock on tractors so equipped. Tractors with TAs also use this flow to control and lube the TA. The oil flow remaining after the 3 GPM is drawn off is sent to the oil cooler and the back through the MCV and routed back to lube the range transmission and differential. Providing the flow divider is working properly in the MCV, if you are experiencing a loss of steering, most likely there is no oil flow going the oil cooler and the rear frame. A weak MCV pump can lead to rear end failures in these tractors.
There should be four bolts with copper washers/gaskets under then in a rectangular pattern. Those are the ones that hold the pump to the MCV assembly. The rest hold the MCV to the center section.
You will need a gasket and O-ring between the MCV and center section. There are two more O-rings to mount the pump. Tractors with S/N 15000 and above also have a spacer plate so an additional gasket and O-ring are used. You would be well advised to go through the entire MCV assemble while it is off. You can inspect for worn springs and scoring on the valves as well as replacing all the O-rings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
