Farmall & IHC Tractors Discussion Board |
Re: Super A ring gear problem or starter?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ltf in nc on July 13, 2000 at 18:06:48 from (206.228.214.107):
In Reply to: Super A ring gear problem or starter? posted by rca on July 13, 2000 at 16:32:03:
Does the starter make a clashing noise or does it spin and sound like an electric drill? With the drill sound the problem is the starter drive. If it clashes it is the ring gear on the flywheel. The next time you stop the tractor engine, let it idle down and with it in gear and the brake on let the clutch out and purposely choke the engine. See if it will restart with the starter. If it does the ring gear is history. I have a tractor that I use infrequently that I stop this way each time due to the same problem you have. By doing this, it stops the engine in a different place than where it normally will coast to a stop. Once you engage the starter with the ring gear in a good spot, the engine will continue to crank. The ring gear will only be damaged in one area.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|