Posted by scotc on February 06, 2011 at 19:31:35 from (72.101.231.77):
In Reply to: Re: Another One posted by Uncle Ed on February 06, 2011 at 19:02:36:
We always had things set up so that pulling lifted. Pull back, raise the bucket. Pull back or sideways, roll it in. I had to switch the swing lines on the diskbine, the left side moved the way the lever was moved, and it screwed me up every time. If the levers had been on the left, it might have worked for me the way it was. I don't care whose equipment it is, if I will be running it for long at all, I will switch the hoses in the remotes to my liking.
If you find it easier, just switch the lines. If it has a float position, I would set it up so that it is on the "down" side.
Another one is the electric tarp on the hopper trailer. The switch is mounted on the side above your head. I look up, and hit the left side, to roll it left. And sometimes get to the end of the driveway before I realize that it's backwards, too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.