Farmall & IHC Tractors Discussion Board |
Re: Carbureator Float Help!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by brandon on July 12, 2000 at 20:41:09 from (209.152.88.234):
In Reply to: Carbureator Float Help! posted by Bruce Simmons on July 12, 2000 at 08:32:16:
I had the same problem on my Super M. Rust builds up in the gas tank and particles get in neddle valve and make it stick. I had to overhaul the carb. Inside the carb overhaul kit it has settings for the float. You need a machinest rule(calipers)to set this. As for set screws, you need to let it run and adjust them until it lets the right amount of gas through. WARNING- The float wiil stick and gas will flow out of the carb. When this happens the tractor will die. take off the air intake pipe and let the gas drain out. take a screwdriver and hit it against the side of the carb to unstick the float. put the air intake back on and turn on the gas. After you get it back in the shed, CHECK YOUR OIL! After mine leaked like that a few times, the oil had so much gas in it it was thinner than water. This is a good way to crack a head or put a hole in the piston. Any way this advice is coming from a 13 year old. But I had the same experience and this is how I fixed it. Good Luck! let me know if it worked. Brandon.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|