Posted by farmallhal on January 28, 2011 at 19:34:21 from (76.2.177.91):
In Reply to: Farmall Brush Hog posted by erkel3 on January 28, 2011 at 17:04:24:
In looking at my IHC McCormick Rotary Cutters brouchure (No. CR-1204-K) there are two different 60" cutting width fast hitch models shown. I believe this brouchure is from the 1960-61 era for reference. The McCormick No. 26 has two ground contact wheels about mid-way back of the deck one on either side while the McCormick No. 28 is shown with a single gauge wheel centered behind the deck. Both of these models have a single rotary cutter blade. There is no reference to a twin blade unit in this brouchure even for wider models for larger tractors. You might have something built by someone other then IHC which was adapted with the fast hitch prongs which could be purchased separately for such applications. A picture would certainly be helpful to identify your unit, Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.