Lots of good points, sounds like some rework. I would have to return oil at the suction opening, don't want that or at the one inch top line. would still be a problem if oil level droped to low I think. Do have a 3/4 inch opening pluged where the control lever went near the top of the liftall housing. Problem is I used a 11 inch clutch liftall with a 12 inch clutch. Don't know if you can see in the picture, made up 5/8 inch spacers to drop housing down to clear since I wasn't using the side openings. Would have to make hole in the center housing bigger to use the side opening or drop housing back out and rework. Already cleaned it after screwing fittings in to make sure no metal was dislodged before installing the cover plate. Oh well. Another question on a 400 hydraulic system they returned oil above the fluid level. Only used them set to single acting with a small cylinder myself. Do they blow oil out the vent with bigger single acting cylinders?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.