If the system is clean to start with, a filter on the return is best just as M Diesel said. On our test machines and customer machines (tractors, skid steer, swathers, combines, etc.), we filtered the return with a finer mesh, in our case a 10 micron filter and customers sometimes used a 25 mic. On customer machines, there was typically just a screen on the suction, but on our test machines we installed a large 74 or 49 micron screen element. We also on test machines had a circulating system, which you will not have on a tractor or implement, that had a large capacity 10 mic filter as well as a cooling or temperature control system.
A couple of things to consider here.... 1. You can not use a very fine micron element in a suction line, because as the filter fills with contaminant, it will "choke off" really quickly, like a snowball effect. and 2. In cold weather conditions, or even just normal cold start conditions, the filter will not flow as easily. Like I said, we over-sized the flow capacity and used a 49 or more often, a 74 mic cleanable steel element.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.