Farmall & IHC Tractors Discussion Board |
Cub 3-PT Conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by george on July 10, 2000 at 14:00:05 from (209.9.254.221):
I've recently acquired a '58 Cub with Fasthitch. What's involved in converting this to a 3-PT hitch? I'm interested in using the tractor for finish mowing with a 60" deck. I would consider either a belly mount or 3-PT. Any comments on cost for either conversion? I can pick-up a used 60" deck for around $500 (Kubota) and with a little support welding, and a a few pulleys, rig it for a belly installation. Is there a bolt-on kit to convert the existing PTO to 540 RPM? Having the 3-PT would be more versatile. Thanks for the advice.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|